2x1meter cut area, hypertherm 1650 100amp plasma with spare plug and play hand torch, runs on mach 2 CNC. Stepper driven open loop, was built to be router as well but always was just plasma. Can give half days training and step by step manual on how to draw in cad using intellicad, can supply that too.
Loads of genuine front end consumables and some china crap ones for working on painted of rusty metals, i built this 15 years ago and it runs everyday. Easy to maintain and repair, no need for call outs at 70 -100 quid an hr, seek "mach2 the art of cnc" with full torch height control, infact i was a beta tester for the THC 15 years ago. This machine has made me thousand over the years, shame to see my baby go. The water is displaced by pressuring the the table which blows the water up to the table on the top, so level can be adjusted.Spares set of slats as well. Must be gone by friday 17th, as closing business down. I have deadlines to meet for next week. Workshop is being painted saturday 18th and must be cleared ready for inspection and new tenant monday 20th, some stuff will go in storage and some will be weighed in for scrap.
Hence it wont be listed again. Dont mistake that i will give it away. The item "Used cnc plasma cutter 100 amp hypertherm 1650 40mm max cut and water table" is in sale since Sunday, September 12, 2021. This item is in the category "Business, Office & Industrial\CNC, Metalworking & Manufacturing\Welding & Soldering Equipment\Welding Equipment & Accessories\Welders, Cutters & Torches\Plasma Cutters".
The seller is "scotxl" and is located in Corby. This item can't be shipped, the buyer must pick up the item.